NEWS & REPORTS

Commercial Motor Vehicle Inspection Levels

Jun 18, 2018 | Articles

Level I – North American Standard Inspection

An inspection that includes examination of driver’s license; Medical Examiner’s Certificate and Skill Performance Evaluation (SPE) Certificate (if applicable); alcohol and drugs; driver’s record of duty status, as required; hours of service; seat belt; vehicle inspection report(s) (if applicable); brake systems; cargo securement; coupling devices; driveline/driveshaft; exhaust systems; frames; fuel systems; lighting devices (headlamps, tail lamps, stop lamps, turn signals and lamps/flags on projecting loads); steering mechanisms; suspensions; tires; van and open-top trailer bodies; wheels, rims and hubs; windshield wipers; buses, motorcoaches, passenger vans or other passenger-carrying vehicles – emergency exits, electrical cables and systems in engine and battery compartments, seating, HM/DG and specification cargo tank requirements, as applicable. HM/DG required inspection items will only be inspected by certified HM/DG and cargo tank inspectors, as applicable.

NOTE: If more than 20 percent of pushrod travel on exposed pushrods cannot be measured, then the inspection would not be considered a Level I Inspection and shall be identified as a Level II Inspection.

NOTE: A five-axle vehicle combination with one axle not measured will still require two defective brakes to be placed out of service under the 20 percent brake criteria.

 

Level II – Walk-Around Driver/Vehicle Inspection

An examination that includes each of the items specified under the North American Standard Level II Walk-Around Driver/Vehicle Inspection Procedure. As a minimum, Level II Inspections must include examination of: driver’s license; Medical Examiner’s Certificate and Skill Performance Evaluation (SPE) Certificate (if applicable); alcohol and drugs; driver’s record of duty status as required; hours of service; seat belt; vehicle inspection report(s) (if applicable); brake systems; cargo securement; coupling devices; driveline/driveshaft; exhaust systems; frames; fuel systems; lighting devices (headlamps, tail lamps, stop lamps, turn signals and lamps/flags on projecting loads); steering mechanisms; suspensions; tires; van and open-top trailer bodies; wheels, rims and hubs; windshield wipers; buses, motorcoaches, passenger vans or other passenger-carrying vehicles – emergency exits, electrical cables and systems in engine and battery compartments, seating, and HM/DG requirements, as applicable. HM/DG required inspection items will only be inspected by certified HM/DG and cargo tank inspectors, as applicable. It is contemplated that the walk-around driver/vehicle inspection will include only those items that can be inspected without physically getting under the vehicle.

 

Level III – Driver/Credential/Administrative Inspection

An examination that includes those items specified under the North American Standard Level III Driver/Credential/Administrative Inspection Procedure. As a minimum, Level III Inspections must include, where required and/or applicable: examination of the driver’s license; Medical Examiner’s Certificate and Skill Performance Evaluation (SPE) Certificate; driver’s record of duty status; hours of service; seat belt; vehicle inspection report(s); and carrier identification and status.

NOTE: Mechanical equipment violations specific to a Level I or Level II Inspection should not be included in a Level III Inspection. If applicable, traffic violations/infractions should be included on a Level III Inspection.

 

Level IV – Special Inspections

Inspections under this heading typically include a one-time examination of a particular item. These examinations are normally made in support of a study or to verify or refute a suspected trend.

 

Level V – Vehicle-Only Inspection

An inspection that includes each of the vehicle inspection items specified under the North American Standard Inspection (Level I), without a driver present, conducted at any location.

 

Level VI – North American Standard Inspection for Transuranic Waste and Highway Route Controlled Quantities (HRCQ) of Radioactive Material

An inspection for select radiological shipments, which include inspection procedures, enhancements to the North American Standard Level I Inspection, radiological requirements and the North American Standard Out-of-Service Criteria for Transuranic Waste and Highway Route Controlled Quantities of Radioactive material.

As of Jan. 1, 2005, all vehicles and carriers transporting HRCQ of radioactive material are regulated by the U.S. Department of Transportation (DOT) and required to pass the North American Standard Level VI Inspection.

Previously, U.S. Department of Energy (DOE) voluntarily complied with the North American Standard Level VI Inspection Program requirements.

Select radiological shipments include HRCQ of radioactive material as defined by Title 49 CFR 173.403. And, because only a small fraction of transuranics are HRCQ, the U.S. DOE decided to include its transuranic waste shipments in the North American Standard Level VI Inspection Program.

 

Level VII – Jurisdictional Mandated Commercial Vehicle Inspection

An inspection that is a jurisdictional mandated inspection program that does not meet the requirements of any other level of inspection. An example will include inspection programs such as, but not limited to, school buses, limousines, taxis, shared-ride transportation, hotel courtesy shuttles and other intrastate/intra-provincial operations. These inspections may be conducted by CVSA-certified inspectors, other designated government employees or jurisdiction-approved contractors. Inspector training requirements shall be determined by each jurisdiction. No CVSA decal shall be issued for a Level VII Inspection but a jurisdiction-specific decal may be applied.

 

Level VIII – North American Standard Electronic Inspection

An examination that includes those items specified under the North American Standard Electronic Inspection Procedure. An electronic inspection must include, where required and/or applicable, a descriptive location, including GPS coordinates; electronic validation of who is operating the vehicle; appropriate driver’s license class and endorsement(s) for vehicle being operated; license status; valid Medical Examiner’s Certificate and Skill Performance Evaluation (SPE) Certificate; current driver’s record of duty status; hours-of-service compliance; USDOT or (Canada) NSC number; power unit registration; operating authority; Unified Carrier Registration (UCR) compliance; and federal out-of-service orders.

The North American Standard Level VIII Electronic Inspection is an inspection conducted electronically or wirelessly while the vehicle is in motion without direct interaction with an enforcement officer. To be considered a complete Level VIII Electronic Inspection, a data exchange must include each of the required and/or applicable data points listed in the CVSA North American Standard Level VIII Electronic Inspection definition.

 

About the Author

NEWS & REPORTS

Hours of service too rigid, Office of Advocacy tells DOT

Mark Schremmer Relaying concerns from truckers, the U.S. Small Business Administration’s Office of Advocacy recently told the Federal Motor Carrier Safety Administration that its hours of service are too rigid. “Advocacy understands that hours-of-service regulations...

Why attention span isn’t the problem with your training program

Mark Murrel Pay attention. Is it true our attention spans are becoming, well, less attentive? After all, smartphones, social media, and all the other high tech gizmos seem to enthrall us on a daily basis. Tech can be a productivity enhancer, but it can also have a...

CVSA’s Upcoming Webinars

Safety Culture: Transforming Fatigue Management from a Liability into a Competitive Advantage Wednesday, May 14, 1-2 p.m. EDT For Members and Non-Members Learn how to foster a safety culture where drivers feel supported, recognize the signs of fatigue, and take...

What to look for in an online training provider

Mark Murrell It’s now 2025, which means I’ve officially been designing and building learning management systems (LMS) for 25 years. Much has changed in that time, and technology and the Internet have allowed us to develop online training tools we wouldn’t have...

Unnecessary regulation? It’s your chance to tell the DOT

Mark Schremmer Truck drivers often vent about the amount of regulations they must follow and how many of them do nothing to improve highway safety. Well, the time has come for truck drivers to do something about it. But the clock is running out. On April 3, the U.S....

CATEGORIES